3D printed lens board for my @intrepidcamera 8x10. I had a hard time finding a board that would fit the Ilex No. 4 shutter that came with the Kodak Wide Field Ektar 190mm/f6.3 lens I picked up recently. So I opened up Fusion 360 and made one, which I then printed on my Ender 3 Pro. First attempt didn’t work; the hole was based on some specs I read online and was too small, and I hadn’t accounted for the rounded corners. Also it wasn’t quite thick enough and so wasn’t rigid enough. So back to Fusion 360, doubled the thickness to 4mm and added a circle to the back for another 2mm of support. The result looks promising. Will have to take the camera out this week and see if it worked.